Options
Cross-influence between the two servo-loops of a fully-stabilized Er:fiber optical frequency comb
Date de parution
2012
In
Journal of the Optical Society of America B
Vol.
29
No
10
De la page
2944
A la page
2957
Résumé
We present a study of the impact of the cross-coupling between the two servo loops used to stabilize the repetition rate ƒ <sub>rep</sub> and the carrier-envelope offset (CEO) frequency ƒ <sub>CEO</sub> in a commercial Er:fiber frequency comb, based on the combination of experimental measurements and a model of the coupled loops. The developed theoretical model enables us to quantify the influence of the servo-loop coupling on an optical comb line, by simulating the hypothetic case where no coupling would be present. Numerical values for the model were obtained from an extensive characterization of the comb, in terms of frequency noise and dynamic response to a modulation applied to each actuator, for both ƒ <sub>rep</sub> and ƒ <sub>CEO</sub>. To validate the model, the frequency noise of an optical comb line at 1.56 μm was experimentally measured from the heterodyne beat between the comb and a cavity-stabilized ultranarrow-linewidth laser and showed good agreement with the calculated noise spectrum. The coupling between the two stabilization loops results in a more than 10-fold reduction of the comb mode frequency noise power spectral density in a wide Fourier frequency range.
Identifiants
Type de publication
journal article
Dossier(s) à télécharger
