Options
Thomann, Pierre
Nom
Thomann, Pierre
Affiliation principale
Fonction
Professeur.e émérite
Email
pierre.thomann@unine.ch
Identifiants
Résultat de la recherche
14 Résultats
Voici les éléments 1 - 10 sur 14
- PublicationAccès libreCross-influence between the two servo-loops of a fully-stabilized Er:fiber optical frequency comb(2012-9-28)
; ; ; ; ; We present a study of the impact of the cross-coupling between the two servo loops used to stabilize the repetition rate frep and the carrier-envelope offset (CEO) frequency fCEO in a commercial Er:fiber frequency comb, based on the combination of experimental measurements and a model of the coupled loops. The developed theoretical model enables us to quantify the influence of the servo-loop coupling on an optical comb line, by simulating the hypothetic case where no coupling would be present. Numerical values for the model were obtained from an extensive characterization of the comb, in terms of frequency noise and dynamic response to a modulation applied to each actuator, for both frep and fCEO. To validate the model, the frequency noise of an optical comb line at 1.56 μm was experimentally measured from the heterodyne beat between the comb and a cavity-stabilized ultranarrow-linewidth laser and showed good agreement with the calculated noise spectrum. The coupling between the two stabilization loops results in a more than 10-fold reduction of the comb mode frequency noise power spectral density in a wide Fourier frequency range. - PublicationAccès libreExperimental Validation of a Simple Approximation to Determine the Linewidth of a Laser from its Frequency Noise Spectrum(2012-7-2)
; ; ; ; ; Laser frequency fluctuations can be characterized either comprehensively by the frequency noise spectrum or in a simple but incomplete manner by the laser linewidth. A formal relation exists to calculate the linewidth from the frequency noise spectrum, but it is laborious to apply in practice. We recently proposed a much simpler geometrical approximation applicable to any arbitrary frequency noise spectrum. Here we present an experimental validation of this approximation using laser sources of different spectral characteristics. For each of them, we measured both the frequency noise spectrum to calculate the approximate linewidth and the actual linewidth directly. We observe a very good agreement between the approximate and directly measured linewidths over a broad range of values (from kilohertz to megahertz) and for significantly different laser line shapes. - PublicationAccès libreNoise properties of an optical frequency comb from a SESAM-modelocked 1.5 µm solid-state laser stabilized to the 10E-13 level(2012-5-26)
; ; ; ; ; ; - PublicationAccès libreLinewidth of a quantum cascade laser assessed from its frequency noise spectrum and impact of the current driver(2012-4-21)
; ; ; ; ; We report on the measurement of the frequency noise properties of a 4.6-μm distributed-feedback quantum-cascade laser (QCL) operating in continuous wave near room temperature using a spectroscopic set-up. The flank of the R(14) ro-vibrational absorption line of carbon monoxide at 2196.6 cm^−1 is used to convert the frequency fluctuations of the laser into intensity fluctuations that are spectrally analyzed. We evaluate the influence of the laser driver on the observed QCL frequency noise and show how only a low-noise driver with a current noise density below ≈1 nA/√Hz allows observing the frequency noise of the laser itself, without any degradation induced by the current source. We also show how the laser FWHM linewidth, extracted from the frequency noise spectrum using a simple formula, can be drastically broadened at a rate of ≈1.6 MHz/(nA/√Hz) for higher current noise densities of the driver. The current noise of commercial QCL drivers can reach several nA/√Hz , leading to a broadening of the linewidth of our QCL of up to several megahertz. To remedy this limitation, we present a low-noise QCL driver with only 350 pA/√Hz current noise, which is suitable to observe the ≈550 kHz linewidth of our QCL. - PublicationAccès libreTemperature dependence of the frequency noise in a mid-IR DFB quantum cascade laser from cryogenic to room temperature(2012)
; ; ; We report on the measurement of the frequency noise power spectral density in a distributed feedback quantum cascade laser over a wide temperature range, from 128 K to 303 K. As a function of the device temperature, we show that the frequency noise behavior is characterized by two different regimes separated by a steep transition at ≈200 K. While the frequency noise is nearly unchanged ~200 K, it drastically increases at lower temperature with an exponential dependence. We also show that this increase is entirely induced by current noise intrinsic to the device. In contrast to earlier publications, a single laser is used here in a wide temperature range allowing the direct assessment of the temperature dependence of the frequency noise. - PublicationAccès libreExperimental validation of a simple approximation to determine the linewidth of a laser from its frequency noise spectrumLaser frequency fluctuations can be characterized either comprehensively by the frequency noise spectrum or in a simple but incomplete manner by the laser linewidth. A formal relation exists to calculate the linewidth from the frequency noise spectrum, but it is laborious to apply in practice. We recently proposed a much simpler geometrical approximation applicable to any arbitrary frequency noise spectrum. Here we present an experimental validation of this approximation using laser sources of different spectral characteristics. For each of them, we measured both the frequency noise spectrum to calculate the approximate linewidth and the actual linewidth directly. We observe a very good agreement between the approximate and directly measured linewidths over a broad range of values (from kilohertz to megahertz) and for significantly different laser line shapes.
- PublicationAccès libreFrequency noise of free-running 4.6 um distributed feedback quantum cascade lasers near room temperature(2011-8-10)
; ; ; ; ; The frequency noise properties of commercial distributed feedback quantum cascade lasers emitting in the 4.6 um range and operated in cw mode near room temperature (277K) are presented. The measured frequency noise power spectral density reveals a flicker noise dropping down to the very low level of <100 Hz2/Hz at 10 MHz Fourier frequency and is globally a factor of 100 lower than data recently reported for a similar laser operated at cryogenic temperature. This makes our laser a good candidate for the realization of a mid-IR ultranarrow linewidth reference. - PublicationAccès libreFrequency discriminators for the characterization of narrow-spectrum heterodyne beat signals: Application to the measurement of a sub-hertz carrier-envelope-offset beat in an optical frequency comb(2011)
; ; ; ; ; ; - PublicationAccès libreFully stabilized optical frequency comb with sub-radian CEO phase noise from a SESAM-modelocked 1.5-µm solid-state laser(2011)
; ; ; ; ; ; - PublicationAccès libreFrequency noise of free-running 4.6 μm distributed feedback quantum cascade lasers near room temperature(2011)
; ; ; ; ; Faist, JérômeThe frequency noise properties of commercial distributed feedback quantum cascade lasers emitting in the 4.6 μm range and operated in cw mode near room temperature (277 K) are presented. The measured frequency noise power spectral density reveals a flicker noise dropping down to the very low level of <100 Hz2/Hz at 10 MHz Fourier frequency and is globally a factor of 100 lower than data recently reported for a similar laser operated at cryogenic temperature. This makes our laser a good candidate for the realization of a mid-IR ultranarrow linewidth reference.