Résultat de la recherche
Influence of reservoir geology on seismic response during decameter-scale hydraulic stimulations in crystalline rock
We performed a series of 12 hydraulic stimulation experiments in a 20 m×20 m×20 m foliated, crystalline rock volume intersected by two distinct fault sets at the Grimsel Test Site, Switzerland. The goal of these experiments was to improve our understanding of stimulation processes associated with high-pressure fluid injection used for reservoir creation in enhanced or engineered geothermal systems. In the first six experiments, pre-existing fractures were stimulated to induce shear dilation and enhance permeability. Two types of shear zones were targeted for these hydroshearing experiments: (i) ductile ones with intense foliation and (ii) brittle–ductile ones associated with a fractured zone. The second series of six stimulations were performed in borehole intervals without natural fractures to initiate and propagate hydraulic fractures that connect the wellbore to the existing fracture network. The same injection protocol was used for all experiments within each stimulation series so that the differences observed will give insights into the effect of geology on the seismo-hydromechanical response rather than differences due to the injection protocols. Deformations and fluid pressure were monitored using a dense sensor network in boreholes surrounding the injection locations. Seismicity was recorded with sensitive in situ acoustic emission sensors both in boreholes and at the tunnel walls. We observed high variability in the seismic response in terms of seismogenic indices, b values, and spatial and temporal evolution during both hydroshearing and hydrofracturing experiments, which we attribute to local geological heterogeneities. Seismicity was most pronounced for injections into the highly conductive brittle–ductile shear zones, while the injectivity increase on these structures was only marginal. No significant differences between the seismic response of hydroshearing and hydrofracturing was identified, possibly because the hydrofractures interact with the same pre-existing fracture network that is reactivated during the hydroshearing experiments. Fault slip during the hydroshearing experiments was predominantly aseismic. The results of our hydraulic stimulations indicate that stimulation of short borehole intervals with limited fluid volumes (i.e., the concept of zonal insulation) may be an effective approach to limit induced seismic hazard if highly seismogenic structures can be avoided.
Hydraulic stimulation and fluid circulation experiments in underground laboratories: Stepping up the scale towards engineered geothermal systems
The history of reservoir stimulation to extract geothermal energy from low permeability rock (i.e. so-called petrothermal or engineered geothermal systems, EGS) highlights the difficulty of creating fluid pathways between boreholes, while keeping induced seismicity at an acceptable level. The worldwide research community sees great value in addressing many of the unresolved problems in down-scaled in-situ hydraulic stimulation experiments. Here, we present the rationale, concepts and initial results of stimulation experiments in two underground laboratories in the crystalline rocks of the Swiss Alps. A first experiment series at the 10 m scale was completed in 2017 at the Grimsel Test Site, GTS. Observations of permeability enhancement and induced seismicity show great variability between stimulation experiments in a small rock mass body. Monitoring data give detailed insights into the complexity of fault stimulation induced by highly heterogeneous pressure propagation, the formation of new fractures and stress redistribution. Future experiments at the Bedretto Underground Laboratory for Geoenergies, BULG, are planned to be at the 100 m scale, closer to conditions of actual EGS projects, and a step closer towards combining fundamental process-oriented research with testing techniques proposed by industry partners. Thus, effective and safe hydraulic stimulation approaches can be developed and tested, which should ultimately lead to an improved acceptance of EGS