Vignette d'image

Dutler, Nathan

Nom
Dutler, Nathan
Affiliation principale
Fonction
Ancien.ne collaborateur.trice
Identifiants
https://libra.unine.ch/handle/123456789/1159

Résultat de la recherche

Filtres

4
4
31
Réinitialiser les filtres

Paramètres

Voici les éléments 1 - 4 sur 4
  • Publication
    Accès libre
    Poroelasticity Contributes to Hydraulic-Stimulation Induced Pressure Changes
    (2021-2)
    Dutler, Nathan 
    ;
    Valley, Benoît 
    ;
    Amann, F.
    ;
    Jalali, M.
    ;
    Villiger, L.
    ;
    Krietsch, H.
    ;
    Gischig, V.
    ;
    Doetsch, J.
    ;
    Giardini, D.
    High-pressure fluid injections cause transient pore pressure changes over large distances, which may induce seismicity. The zone of influence for such an injection was studied at high spatial esolutions in six decameter-scaled fluid injection experiments in crystalline rock. Pore pressure time series revealed two distinct responses based on the lag time and magnitude of pressure change, namely, a near- and far-field response. The near-field response is due to pressure diffusion. In the far-field, the fast response time and decay of pressure changes are produced by effective stress changes in the anisotropic stress field. Our xperiments confirm that fracture fluid pressure perturbations around the injection point are not limited to the near field and can extend beyond the pressurized zone.
  • Publication
    Accès libre
    In situ observation of helium and argon release during fluid-pressure triggered rock deformation
    (2020-10)
    Roques, Clément 
    ;
    Weber, U. W.
    ;
    Brixel, B.
    ;
    Krietsch, H.
    ;
    Dutler, Nathan 
    ;
    Brennwald, M. S.
    ;
    Villiger, L.
    ;
    Doetsch, J.
    ;
    Jalali, M.
    ;
    Gischig, V.
    ;
    Amann, F.
    ;
    Valley, Benoît 
    ;
    Klepikova, M.
    ;
    Kipfer, R.
    Temporal changes in groundwater chemistry can reveal information about the evolution of flow path connectivity during crustal deformation. Here, we report transient helium and argon concentration anomalies monitored during a series of hydraulic reservoir stimulation experiments measured with an in situ gas equilibrium membrane inlet mass spectrometer. Geodetic and seismic analyses revealed that the applied stimulation treatments led to the formation of new fractures (hydraulic fracturing) and the reactivation of natural fractures (hydraulic shearing), both of which remobilized (He, Ar)-enriched fluids trapped in the rock mass. Our results demonstrate that integrating geochemical information with geodetic and seismic data provides critical insights to understanding dynamic changes in fracture network connectivity during reservoir stimulation. The results of this study also shed light on the linkages between fluid migration, rock deformation and seismicity at the decameter scale.
  • Publication
    Accès libre
    Hydromechanical insight of fracture opening and closure during in-situ hydraulic fracturing in crystalline rock
    (2020-9)
    Dutler, Nathan 
    ;
    Valley, Benoît 
    ;
    Gischig, V.
    ;
    Jalali, M.
    ;
    Brixel, B.
    ;
    Krietsch, H.
    ;
    Roques, Clément 
    ;
    Amann, F.
    Six hydraulic fracturing (HF) experiments were conducted in situ at the Grimsel Test Site (GTS), Switzerland, using two boreholes drilled in sparsely fractured crystalline rock. High spatial and temporal resolution monitoring of fracture fluid pressure and strain improve our understanding of fracturing dynamics during and directly following high-pressure fluid injection. In three out of the six experiments, a shear-thinning fluid with an initial static viscosity approximately 30 times higher than water was used to understand the importance of fracture leak-off better. Diagnostic analyses of the shut-in phases were used to determine the minimum principal stress magnitude for the fracture closure cycles, yielding an estimate of the effective instantaneous shut-in pressure (effective ISIP) 4.49±0.22 MPa. The jacking pressure of the hydraulic fracture was measured during the pressurecontrolled step-test. A new method was developed using the uniaxial Fibre-Bragg Grating strain signals to estimate the jacking pressure, which agrees with the traditional flow versus pressure method. The technique has the advantage of observing the behavior of natural fractures next to the injection interval. The experiments can be divided into two groups depending on the injection location (i.e., South or North to a brittle-ductile S3 shear zone). The experiments executed South of this zone have a jacking pressure above the effective ISIP. The proximity to the S3 shear zone and the complex geological structure led to near-wellbore tortuosity and heterogeneous stress effects masking the jacking pressure. In comparison, the experiments North of the S3 shear zone has a jacking pressure below the effective ISIP. This is an effect related to shear dislocation and fracture opening. Both processes can occur almost synchronously and provide new insights into the complicated mixedmode deformation processes triggered by high-pressure injection.
  • Publication
    Accès libre
    Observations of fracture propagation during decameter-scale hydraulic fracturing experiments
    (: American Rock Mechanics Association, 2018-6-17)
    Dutler, Nathan 
    ;
    Valley, Benoît 
    ;
    Gischig, V.
    ;
    Jalali, M.
    ;
    Doetsch, J.
    ;
    Krietsch, H.
    ;
    Villiger, L.
    ;
    Amann, F.
    Various in-situ hydraulic fracturing experiments were carried out in the naturally fractured, crystalline rock mass of the Grimsel Test Site (GTS) in Switzerland. The purpose was to study the geometry of the newly created fractures and their interaction with the pre-existing fracture network using transient pressure and rock mass deformation observations. Under controlled conditions, six hydraulic fractures with similar injection protocols were executed in two sub-vertical injection boreholes. The rock mass is intersected by two E-W striking shear zones (S3), and two biotite-rich meta-basic dykes with a densely fractured zone in between. The S3 shear-zone intersecting the rock volume of interest acts as a high-permeability connection to the tunnel for the experiments executed south of it. Strong variation in injectivity enhancement, jacking pressure, break down pressure, instantaneous shut-in pressure and fluid flow recovery among the different injection intervals indicate different stress conditions north and south of S3.